The cooling liquid produced by the company incorporates the coating capability of the particles and the ions of the elements in the water Incapsulated and makes them non-adhesive to the positive and negative poles that are always present in the welding and cutting systems. By relying on its advanced and unique formula, the remaining deposits remain separated from the device. Also, by increasing the transfer coefficient and heat exchange of water, it causes the cooling of faster and better permanent and consumable tools such as turret chamber, nozzle and nozzle. Flame and electrode cutting and cables, and … in the systems of welding and cutting, and as a result, the life of the components and the efficiency of their work in the working conditions significantly and significantly increases.
Practical and Important Tips for Cooling Consumers:
In many cases, it has been observed that non-specialist people use anti-icing and anti-burning machines as a coolant for cutting and welding machines, and since an anti-freeze and anti-freeze vehicle has high levels of chemical and industrial molecules (With active elements), and on the other hand, as you know, the nature of the color particles also has electrostatic loads, and as a result, when it enters the cooling system, the internal wall is attached to the parts and two of them cause serious damage to the machine and The process of welding or cutting is described below:
۱- The formation of a thin layer of micron in the color of the vehicle coolant fluid or colored liquid that the above layer serves as an insulator prevents the heat exchange of metal with water, which in some cases also has a thickness of several hundredths of a millimeter arrives .
Surface texture and molecular arrangement of the paint layer formed inside the water channels as well as the electrostatic properties of colors are effective and double factors to absorb and form resistant and hard and stable layers of sediments and mineral elements in water such as sodium, potassium, magnesium, calcium And … that ultimately leads to the following excuse:
The overheating of the boiling torch or cutting in the operator’s hands, loosening and damage to all its metallic and non-metallic joints, and the operator’s dissatisfaction with excessive heat during take-up
Hot internal parts of the machine and overheating of the unit supplying the electric energy and reducing the amperage power at the output of the welding machine, and finally the frequent stopping of the machine and the production line due to the rising temperature and the lack of stability of the voltage and output ampere
Lowering the life and hours of operation of internal and external components such as tube contacts, nozzles, flames (torch cavity), cutting electrodes, cable, power transmission to the turf, insulating fibers and their location up to 60% of the useful lifetime of the components.
Significant rise in the amount of energy consumed in the long-term financial and economic terms and the cost of overhead
The lack of arc stability, both in cutting and in the boiling process, and in reducing the quality of the workpiece, and many other similar things
Freezing of water inside the water-borne unit and inability to operate the welding machine, and in the case of working with coincident with serious damage to the welding machine