پودر تیزکن الکترود تنگستن جوشکاری
TUNGESTEN CHEMICAL SHARPNER
Usage of Tizan Sharpen Powder:
First, turn the turret sequence a bit so that the tungsten electrode is released a bit, then pull the tip of the electrode out to place it in place 3 to 4 cm, then create a short arc on the desktop until the beginning of the tungsten electrode 5 to 10 mm in red And then melt immediately, then immerse the red and thawed part of the electrode in a thinner powder and turn it up for a few seconds and prevent other parts of the torch parts from being powdered. Now, the tip of your electrode is in the best and most accurate way. The angles and shapes are thoroughly professional and standard, sharpened and ready to use.
Practical and Important Tips:
- It should be noted that in order to sharpen the number of droplets of the electrode in the powder, make sure to avoid rotating the electrode inside the powder (in this way, the tip of your electrode is dipped 10 to 15 times, and from the dipped powder to the limit The tip of a sharp sewing needle is sharpened).
- To curl or bend the electrode, simply insert the electrode into the powder and only slowly rotate and rotate, and avoid the top and bottom of the electrode in the powder.
- To clean the dirt on the surface of the tungsten electrode, which is left to the filler of the welders while working, it is only enough to put two to three times the electrode into the powder and bring out the powder at the same time as the rotation and time.